FrameGraph node to transfer a rectangle of pixel values from one region of a render target to another. More...
| Import Statement: | import Qt3D.Render 2.4 |
| Since: | Qt 5.10 |
| Instantiates: | QBlitFramebuffer |
| Inherits: |
This node inserts a glBlitFrameBuffer or an equivalent into the command stream. This provides a more efficient method for copying rectangles between textures or surface backbuffers wrapped by QRenderTarget than
drawing textured quads. It also supports scaling with the specified interpolation method.
Note: In practice the BlitFramebuffer node will often be used in combination with NoDraw since a blit should not involve issuing draw calls for any entities.
|
destination : RenderTarget |
Specifies the destination render target. When not set, the destination is assumed to be the default framebuffer (i.e. the backbuffer of the current surface), if there is one.
Note: the source and destination must not refer to the same render target.
|
destinationAttachmentPoint : RenderTargetOutput.AttachmentPoint |
Specifies the source attachment point. Defaults to RenderTargetOutput.AttachmentPoint.Color0.
|
destinationRect : Rect |
Specifies the destination rectangle. The coordinates are assumed to follow the normal Qt coordinate system, meaning Y runs from top to bottom.
|
interpolationMethod : InterpolationMethod |
Specifies the interpolation applied if the image is stretched. Defaults to Linear.
|
source : RenderTarget |
Specifies the source render target. When not set, the source is assumed to be the default framebuffer (i.e. the backbuffer of the current surface), if there is one.
Note: the source and destination must not refer to the same render target.
|
sourceAttachmentPoint : RenderTargetOutput.AttachmentPoint |
Specifies the source attachment point. Defaults to RenderTargetOutput.AttachmentPoint.Color0.
|
sourceRect : Rect |
Specifies the source rectangle. The coordinates are assumed to follow the normal Qt coordinate system, meaning Y runs from top to bottom.
